Wood Brightener EB100 - lightens furniture, oak and dark woods

The Wood Brightener EB100 is ideal for brightening, staining or brightening your wooden furniture. It is suitable for all types of wood such as dark oak and removes stains such as tannins, rust, metals, wine, coffee, ink and rings from flower vases. It lightens blackened, dark, dirty or weathered woods. This product restores the original appearance of floors, worktops, furniture and other interior woods. Economical and effective, its gel formula allows a prolonged action and prevents the product from evaporating quickly. Formulated in an aqueous phase, odourless and VOC-free (COV in french), it is perfectly suited for indoor use. Also suitable for use on garden furniture and outside maidservants.

Benefits

• Suitable for all types of wood (even exotic ones), such as oak.
• Brightens dark or dirty furniture and other wooden surfaces
• Restores the original appearance of blackened wood and eliminates the greying of the wood.
• Eliminates tannin stains and drips (oak or chestnut).
• Removes rust stains and traces of metallic oxidation
• Removes even old, thin stains (coffee, wine, ink, vase rings, etc.).
• Does not alter the wood
• Powerful and fast action
• In gel form: does not drip
• Odourless
• Rinsing with water
• Biodegradable
• Revives dull woods

PRECAUTIONS BEFORE APPLICATION

• Do not apply at temperatures below 5°C (41F).
• Do not apply on metal (iron or stainless steel).
• Do not apply with a metal object.
• Keep out of the reach of children.
• Avoid contact with skin and eyes.

INSTRUCTIONS FOR USE

WOOD PREPARATION

• The wood must be clean, dry and dust-free.

APPLICATION OF WOOD BRIGHTENER

• Ready to use product. No dilution is necessary.
• Make sure that the ambient temperature is above 5°C (41F).
• Apply a generous coat of the wood thinner with a brush or a paintbrush in the direction of the wood grain.
• Scrubbing increases the effectiveness of the product against tannin stains.

LET IT ACT

• Leave the wood lightening product to work for 30 minutes without allowing it to dry.

RINSING

• Brush again by rinsing with water in the direction of the wood grain.
• If the substrate is very dirty or if tannin or other stains are stubborn, repeat the operation with the thinner.

DRYING

• Allow to dry thoroughly (24 hours minimum) before applying a finish.

TIPS

• To appreciate the final result, first test the wood thinner on a scrap or an inconspicuous area.
• It is preferable to apply the product away from the sun to avoid evaporation before rinsing.